7
1)
Options / model variants
Original instruction
0
300
CUT OUT
1
°F
210
80
85
°C
175
105
120
60
140
70
160
90
195
100
30
40
50
0
2%
1%
3%
4%
3 Before starting the cleaner
3.1 Setting up the cleaner Every fuel-burning appliance,
such as pressure washers, de-
pends upon a proper mix of fuel
and air (by weight) for proper
combustion. Therefore some
adjustment of the air regulation
to the burner may be necessary
to take account of altitude and
the resulting air pressure. This
is true whether your fuel is Ker-
osene or Diesel.
Your Nilfisk hot water pressure
washer was thoroughly tested
and adjusted for optimum per-
formance before it left our fac-
tory. The factory is located at ap-
proximately 140m (450 ft) above
sea level, and the combustion
settings are optimal for that el-
evation.
If your location is higher than
1200m (3900 ft) above sea lev-
el, your burner may require re-
adjustment for proper perfor-
mance and best fuel economy.
Contact your Dealer or Nilfisk
for assistance.
3.2 Before use 1. Before using the cleaner for
the first time, check it care-
fully to detect any faults or
damage.
2. Run the machine only when
it is in perfect condition.
3. The slope on which the high
pressure cleaner is placed
must not exceed more than
10
o
in any direction.
3.3 Fill up detergent tank
1)
1. Fill up detergent tank with
prediluted detergent.
Capacity see chapter 9.4 Tech-
nical Data
Max 10
°
To Next Page
Loading...
Need help?
General
