FORM NO. 56041342 / SHADOW
™
17/20 - 9
OPERATION
1 Unwrap the Power Cord and plug it into a properly grounded outlet.
2 Loosen the foot operated “Quick-Loc” lever with the toe of your foot by pulling up on the bottom of the lever. Move
the Operator Handle downward until your arms are almost straight. Then step down on top of the lever to lock it.
3 Lift the Handle until the brush (or pad) is flat against the floor.
WARNING!
Be prepared to control the machine as soon as the motor starts.
Just a slight up or down movement of the Handle will make the machine move from side to side. Raise the Handle to go
right. Lower the Handle to go left.
CAUTION!
Immediately start moving the machine back and forth. Keep the machine moving while the motor is running to avoid damage
to the floor or carpet.
4 Hold one of the Operator Hand Grips firmly, push the Safety Lock Button and then compress the switch levers to start
the motor. NOTE: When the dual controlled switch levers are released, the machine shuts off immediately.
NOTE: When spray buffing, check the pad every 15 minutes for dirt and wax build-up. If the pad is dirty, turn it over
to expose the clean side or install a clean pad.
To Next Page
Loading...
Need help?
General
