Nilfisk-ALTO ATTIX 30 User Manual (English)

Other manuals for Nilfisk-ALTO ATTIX 30

Operating Instructions29 pages

Service Manual30 pages

Questions and Answers:

R
richardandersonAug 13, 2025
Why does my Nilfisk-ALTO ATTIX 30 have reduced suction power and make acoustic warnings?
- D
  Danielle WoodsAug 13, 2025
  The acoustic warning and reduced suction power in your Nilfisk-ALTO Vacuum Cleaner can be caused by several issues: * The suction power may be set too low, adjust it according to the manual. * The hose diameter might not match the switch position; adjust the switch accordingly. * The suction hose or nozzle could be clogged; clean them. * The tank, disposal bag, or filter bag may be full; empty the tank or replace the bags. * The filter element might be clogged; clean or replace it. * The seal between the tank and the upper section of the vacuum cleaner could be faulty or missing; replace the seal. * The cleaning mechanism may be defective; in this case, contact Nilfisk-Alto Service.
K
Kelly PerezAug 16, 2025
What to do if my Nilfisk-ALTO ATTIX 30 motor does not start?
- M
  Megan PageAug 16, 2025
  If the motor of your Nilfisk-ALTO Vacuum Cleaner doesn't start, check the following: * Ensure the mains socket fuse hasn't blown; connect the mains fuse if needed. * If the overload protection switch has tripped, switch off the vacuum cleaner and let it cool for about 5 minutes. If it still won't start, contact Nilfisk-Alto service. * If the motor is faulty, have it changed by Nilfisk-Alto Service.
J
jessica20Aug 20, 2025
Why won't my Nilfisk-ALTO Vacuum Cleaner motor run in automatic mode?
- M
  Mrs. Melanie Avery DVMAug 20, 2025
  If your Nilfisk-ALTO Vacuum Cleaner motor doesn't run in automatic mode: * Check the power tool or pneumatic tool for defects and ensure it's properly connected. * Verify that the power rating of the electrical tool is greater than 40W.
N
Nicole SmithAug 25, 2025
How to resolve voltage fluctuations with my Nilfisk-ALTO ATTIX 30 Vacuum Cleaner?
- S
  Scott BennettAug 25, 2025
  To address voltage fluctuations with your Nilfisk-ALTO Vacuum Cleaner, connect it to a socket closer to the fuse box. Voltage fluctuations should not exceed 7% if the impedance at the transfer point is ? 0.15 ?.
M
Michael WhiteAug 28, 2025
Why Nilfisk-ALTO Vacuum Cleaner has reduced suction power?
- D
  danielle99Aug 28, 2025
  Reduced suction power in your Nilfisk-ALTO Vacuum Cleaner can occur for several reasons: * The suction power setting might be too low; adjust it according to the instructions. * The suction hose or nozzle may be clogged; clean them. * The tank, disposal bag, or filter bag might be full; empty the tank or replace the bags. * The filter element could be clogged; clean or replace it. * The seal between the tank and the upper section of the vacuum cleaner may be faulty or missing; replace the seal. * The cleaning mechanism might be defective, in which case you should contact Nilfisk-Alto Service.
W
Wesley WallsSep 1, 2025
What to do if my Nilfisk-ALTO ATTIX 30 Vacuum Cleaner has no suction power during wet cleaning?
- J
  James JohnstonSep 1, 2025
  If your Nilfisk-ALTO Vacuum Cleaner lacks suction power during wet cleaning, it's likely that the tank is full. To resolve this, switch off the cleaner and empty the tank.
M
Mrs. Nicole BrownSep 4, 2025
Why Nilfisk-ALTO ATTIX 30 motor does not run in automatic mode?
- K
  Kevin PughSep 4, 2025
  If the motor of your Nilfisk-ALTO Vacuum Cleaner does not run in automatic mode, it could be due to the following reasons: * The power tool or pneumatic tool is defective or not connected properly; ensure the power tool works and the plug is correctly inserted. * The power rating of the electrical tool is too low; make sure the minimum power rating is above 40W.
D
Diana KingSep 8, 2025
How to fix voltage fluctuations in Nilfisk-ALTO Vacuum Cleaner?
- E
  Erin DuncanSep 8, 2025
  To address voltage fluctuations with your Nilfisk-ALTO Vacuum Cleaner, connect the cleaner to another socket closer to the fuse box. Voltage fluctuations over 7% should not occur if the impedance at the transfer point is ? 0.15 ?.

Nilfisk-ALTO ATTIX 30 Specifications

General

Category	Vacuum Cleaner
Tank Capacity	30 l
Airflow	3700 l/min
Vacuum Pressure	250 mbar
Hose Length	2.5 m
Dimensions	450 x 380 x 595 mm
Model	ATTIX 30
Mains connection	230 V, 50-60 Hz
Cable Length	7.5 m