15
1)
Options / model variants
Original instructions
NEPTUNE 3
6 After using the cleaner
6.1 Switching off the
cleaner
1. Turn the main switch to posi-
tion „OFF“.
2. Close water tap.
3. Squeeze the spray gun
handle until the cleaner is
depressurised.
4. Lock the safety catch on the
spray gun.
6.2 Disconnecting supply
lines
1. Close water tap.
2. Squeeze the spray gun
handle until the cleaner is
depressurised.
3. Lock the safety catch on the
spray gun.
6.3 Rolling up the electrical
lead and storing
accessories
Risk of tripping!
To prevent accidents, always
carefully roll up the electrical
lead.
1. Wind up the cord
2. Wind up the high pressure
hose.
3. Place the spray lance into
the spray lance storage.
4. Switch off the cleaner.
5. Remove the water hose
from the cleaner.
6. Pull out the plug from the
electrical socket.
6.4 Storing the cleaner
(below 0°C)
Store the cleaner in a dry room
without danger of frost or pro-
tect as below:
1. Remove the water inlet hose
from the cleaner.
2. Remove the spray lance.
3. Switch on the cleaner with
the main switch in position
"Cold Water".
4. Operate the spray gun.
5. Gradually pour antifreeze
(approx. 5 litres) into the
water tank (A).
6. During suction operate
the spray gun two or three
times.
7. The machine is protected
against frost when antifreeze
solution emerges from the
spray gun.
8. Lock the safety catch on the
spray gun.
9. Switch off the cleaner.
10. To avoid any risks, store
the cleaner temporarily in a
heated room before using it
again.
11. When the machine is put
into service again, the anti-
freeze solution can be col-
lected and stored for future
use.
A
A
To Next Page
Loading...
Need help?
General
