13 141-877-646-5288 ninjakitchen.com
CARE &
MAINTENANCE
CLEANING
1 Separate all parts.
2 Hand Washing
Wash blade assemblies in warm, soapy
water using a dishwashing utensil with
a handle to avoid direct contact with the
blades. Exercise care when handling
blade assemblies as the blades are sharp.
Thoroughly rinse and air-dry all parts.
Dishwasher
All attachments are dishwasher safe. It is
recommended that the lid, container, and
blade assemblies be placed on the top
rack of the dishwasher
ONLY
. Ensure blade
assemblies are removed from the container
before placing in the dishwasher. Exercise
care when handling blade assemblies.
3 Wipe the motor base with a clean, damp
cloth. Allow to dry completely before
operation.
STORING
Wrap the power cord around the back of the
motor base. Store the unit upright and store
all blade assemblies inside or attached to the
container with the lid locked into place.
DO NOT
stack items on top of the container.
Store any remaining attachments alongside the
appliance or in a cabinet where they will not be
damaged or create a hazard.
RESETTING THE MOTOR THERMOSTAT
This appliance features a unique safety system
that prevents damage to the motor and drive
system should you inadvertently overload the
appliance. If the appliance is overloaded, the
motor will be temporarily disabled. Should this
occur, follow the reset procedure below.
1 Unplug the appliance from the
electricaloutlet.
2 Allow the appliance to cool for
approximately 15 minutes.
3
Remove the container lid and blade assembly.
Empty the container and ensure no ingredients
were jamming the blade assemblies.
4 Reset the unit in accordance with the
applicable instructions for the container
and blade type.
IMPORTANT: Ensure that maximum
capacities are not exceeded. This is the
most typical cause of appliance overload.
If your unit needs servicing, please call
Customer Service at 1-877-646-5288.
ORDERING REPLACEMENT PARTS
To order additional parts and attachments,
please visit ninjakitchen.com or contact
customer service at 1-877-646-5288.
TROUBLESHOOTING
GUIDE
WARNING: To reduce the risk of shock and unintended operation, turn
power o and unplug unit before troubleshooting�
Unit does not turn on�
• Make sure unit is plugged in.
• Lower container onto base and twist clockwise until it clicks. Programs will illuminate, indicating that your unit
is ready for use.
Unit does not turn o�
• Remove container from base by rotating it counterclockwise and lifting it up. Display should turn off. Unplug
the power cord from the outlet.
Food is not evenly chopped�
• For best results when chopping, cut pieces down to even sizes and do no overfill the Precision
Processor
™
Bowl.
Motor base will not stick to counter or tabletop�
• Make sure surface and suction feet are wiped clean. Suction feet will only stick to smooth surfaces.
• Suction feet will not stick on some surfaces such as wood, tile, and non-polished finishes.
•
DO NOT
attempt to use appliance when the motor base is stuck to a surface that is not secure (cutting
board, platter, plates, etc.)
Unit is dicult to remove from counter for storage�
• The suction feet at the base of the unit provide stability when in use. To release suction, gently pull the unit
toward you.
Unit turned o while in use�
• As a safety feature to prevent damage to the motor and drive system, this unit will power off after a continuous
run of 45 seconds or more.
To Next Page
Loading...
Need help?
General
