5
Important Information
For the most accurate results using TRUEtrack:
• Read all instructions before testing.
• TRUEtrack is an in vitro (outside body) quantitative
system that is used for self-testing and point-of-care
(bedside) testing of human whole blood only.
• Check Codes. Code in Meter Display must match
Code on vial of TRUEtrack Test Strips being used and
Code Number printed on Code Chip.
• Meter displays results as plasma values.
• Use only TRUEtrack Test Strips and TRUEcontrol
®
Glucose Control Solution with TRUEtrack Meter.
• Do not use for diagnosis of diabetes or for testing
blood glucose in newborns.
• The TRUEtrack is recommended for testing of
human capillary whole blood only. TRUEtrack is not
recommended for use with venous samples.
• Perform Quality Control Testing before performing a
blood test for the first time.
Note: Three levels of TRUEcontrol Glucose Control
Solution are available for Quality Control
Testing. We recommend testing at least 2 levels
of Control. Contact place of purchase or call for
assistance to obtain Control.
• Set date and time for correct Morning Average values.
• When using the meter for the first time, check the
unit of measure in the meter Display after performing
a control or blood test. Result must display in the
correct unit of measure (mg/dL).
• If the result does not display in the correct unit of
measure, DO NOT use the meter and DO NOT use
the meter result to determine treatment.
To Next Page
Loading...
