17
➔ Empty the water tank (fig. 1/B
and 2) and screw the filter into
the bracket provided in the water
reservoir using the assembly tool
on the end of the measuring
spoon.
➔ Fill up the reservoir with fresh
water and replace it in the
machine. Symbol 16 flashes.
➔ Hold a container under the
steam / hot water jet (fig. 1/T)
and turn the control knob (fig. 1/Q
and 7) to the right to open. The
system will now be rinsed out.
➔ Wait until no more water comes
out of the jet for a short time and
turn the control knob (fig. 1/Q
and 7) back to the left to close.
(Caution! If water continues to
come out of the jet after a short
while, the system is also ready.
If this occurs, turn the control
knob back to the left anyway.)
➔ The system briefly warms up
(Symbol 8 flashes) and is then
operational again.
➔ Note: The Service button (fig.
1/I) may still flash. Press the but-
ton (fig. 1/I) and the system will
briefly be rinsed out via the coffee
spout (fig. 1/J und 5).
Important: If you use a filter for
your machine and have changed
the function setting to ‘filter ON’,
the water hardness and manual
descaling functions will no longer
be shown. The filter loses its effi-
ciency after processing about 50 l
of water (for changing filter, see
chapter 5.2).
Caution! If the machine is rarely
used and so the ‘CHANGE FILTER’
signal does not appear in the dis -
play, the filter must be replaced
anyway after no longer than two
months (see chapter 5.2 ‘Washing
filter manually’).
Operating without a filter:
If you no longer wish to use a
filter, the filter setting must be
changed back to ‘filter OFF’. This
is important, as without a filter
the machine must be descaled
(the machine is delivered in the
default setting ‘Without filter’).
➔ Switch your machine off (stand-
by mode) by pressing the On / Off
button (fig. 1/F).
➔ Press and hold the Service but-
ton (fig. 1/I) for about 4 seconds
to enter programming mode.
➔ Symbols 20, 8 and 16 light up
and rotate sequentially in the
display.
... 4. Programming functions
To Next Page
Loading...
