22
➔ The machine rinses itself briefly
out and Symbol 19 starts to flash.
Tip: Place a sufficiently container
(about 0.5 l) under the coffee
spout (fig. 1/J and 5).
➔ Put a cleaning tablet into the
ground coffee chamber (fig. 1/O)
and close the lid. The Service
button (1/I) flashes.
➔ Press the Service button (fig. 1/I).
➔ The machine starts the cleaning
operation.
➔ The cleaning operation runs
automatically and lasts about
10 minutes. As soon as the cycle
is complete, Symbol 17 flashes.
➔ Empty, clean and replace the
drip tray (fig. 1/L).
➔ Refill the water reservoir
(fig. 1/B and 2) with fresh water
if required.
➔ The machine warms up briefly
and is then operational again.
Manual cleaning
If required, the cleaning program
can also be started even if no in -
dication has been displayed by the
machine that this is necessary:
➔ Switch your machine on
(operat ing mode) by pressing the
On / Off button (fig. 1/F).
➔ Press and hold the Service but-
ton (fig. 1/I) for about 4 seconds.
Symbols 19, 20 and / or 18 light
up sequentially in the display.
➔ Wait until Symbol 19 lights up
and press the Service button
(fig. 1/I) to confirm. Symbol 19
starts to flash.
➔ Press and hold the Service
button (fig. 1/I) again for about
4 seconds. Symbol 17 flashes.
➔ Follow the instructions given in
point 5.3, from “Remove the drip
tray …”.
Tip: If you start the manual clean -
ing program by accident, you can
cancel the operation at the start
by pressing and holding the On /
Off button (fig. 1/F) for about
4 seconds.
5.4 Descaling
Note: The descaling function does
not work if the filter program is
set to ‘operation with filter’ (see
point 4.1 ‘Operating without a
filter’). When the machine needs
to be descaled, Symbol 18 ap -
pears in the display and the
Ser vice button (fig. 1/I) flashes.
How ever, you can start the des cal -
ing program manually at any time
(see under ‘Manual descaling’).
... 5. Maintenance and care
To Next Page
Loading...
