20
5. Maintenance and care
➔ Press and hold the Service but-
ton (fig. 1/I) for about 4 seconds
to enter programming mode.
➔ Symbols 20, 18, 8 and 16 light
up and rotate sequentially in the
display.
➔ Wait until the symbol for the
automatic stand-by function, Sym-
bol 16, lights up and press the
Selection button (fig. 1/E and 6).
➔ Symbols 14 and 11 start to
flash.
➔ Press the Selection button (fig.
1/E and 6) until the symbols for
the desired setting flash.
➔ Press and hold the Service but-
ton (fig. 1/I) for about 4 seconds
to confirm.
➔ The programming operation is
now complete and the system
returns to stand-by mode.
5.1 Inserting filter
See chapter 4.1 ‘Filter – Inserting
filter’.
5.2 Changing filter
Filter loses its efficiency after pro-
cessing about 50 l of water. Sym-
bol 20 appears in the display
and the Service button (fig. 1/I)
flashes.
Tip: Only press the Service button
(fig. 1/I) when you wish to change
filter. You can continue to make
coffee, hot water or steam. How -
ever, we recommend that you
change the filter immediately.
➔ Press and hold the Service but-
ton (fig. 1/I) for about 4 seconds.
Symbols 13, 16 and 20 flash.
➔ Empty the water reservoir (fig.
1/B and 2) and replace the filter
(see point 4.1).
➔ Fill up the reservoir with fresh
water and replace it in the ma -
chine.
➔ Hold a container under the
steam / hot water jet (fig. 1/T) and
turn the control knob (fig. 1/Q
and 7) to the right to open. The
system is rinsed through.
➔ Wait until no more water comes
out of the jet for a short time and
turn the control knob (fig. 1/Q
and 7) back to the left to close.
... 4. Programming functions
To Next Page
Loading...
