24
➔ The system is again rinsed out
in intervals, this time through the
steam / hot water jet (fig. 1/T)
(about 5 mins).
➔ As soon Symbol 16 starts flash -
ing again, you can turn the control
knob (fig. 1/Q and 7) back to the
left to close.
➔ The system is rinsed out at
intervals through the inside spout
(about 5 minutes).
➔ As soon as the rinse is com -
pleted, Symbol 17 starts flashing.
➔ Empty the drip tray (fig. 1/L)
and replace it in the machine.
➔ The system warms up briefly.
Then the Service button flashes
(fig. 1/I).
➔ Press the Service button
(fig. 1/I) and the system is rinsed
out through the coffee spout
(fig. 1/J and 5)
➔ The machine is now once again
operational.
Manual descaling
If required, the descaling program
can also be started even if no indi-
cation has been displayed by the
machine that this is necessary:
➔ Switch your machine on
(operat ing mode) by pressing the
On / Off button (fig. 1/F).
➔ Press and hold the Service but-
ton (fig. 1/I) for about 4 seconds.
Symbols 18 and 19 light up and
alternate in the display.
➔ Wait until Symbol 18 lights up
and press the Service button
(fig. 1/I) to confirm. Symbol 18
starts to flash.
➔ Press and hold the Service but-
ton (fig. 1/I) for about 4 seconds.
Symbol 17 flashes.
➔ Follow the instructions given in
point 5.4, from “Empty the drip
tray …”.
Tip: If you start the manual des -
caling program by accident, you
can cancel the operation at the
start by pressing and holding the
On / Off button (fig. 1/F) for about
4 seconds. The machine may ask
you to change the water.
5.5 General cleaning
Caution: Never submerge the
machine in water! Do not use
abrasive materials to clean the
machine.
➔ Wash the case inside and out
with a soft, damp cloth only.
➔ Empty the drip tray (fig. 1/L)
and the used coffee container
(fig. 1/U) only when instructed to
... 5. Maintenance and care
To Next Page
Loading...
