Noble HT-180EC - Voltage Check; Surrounding Area; Temperature Setpoints

07610-004-92-22-A
10
INSTRUCTIONS
INSTALLATION
Apply power to machine. Check the incoming power at the terminal block and
ensure it corresponds with the voltage listed on the data plate. If not, contact a
qualied service agency to examine the problem. Do not run the machine if voltage
is too high or too low. Shut o󰀨 the service breaker and advise all proper personnel
of the location of the breaker and any problems. Replace the control box cover and
tighten-down the screws.
This is a commercial dishmachine and reaches temperatures that can exceed those
generated by a residential machine. Surrounding countertops, cabinets, ooring mate-
rial, and subooring material must be designed and/or selected with these higher
temperatures in mind.
Any damage to surrounding area caused by heat/moisture to materials that
are not recommended for higher temperatures will not be covered under
warranty or by the manufacturer.
The temperature setpoints on this machine have been set at the factory. They
should only be adjusted by an authorized service agent.
TEMPERATURE
SETPOINTS
SURROUNDING
AREA
NOTICE
VOLTAGE CHECK
i