To Next Page

To Previous Page

Mode Explanation

Standby

Press & Hold

(3 Seconds)

No Power

14.5V | 5A | Up To 120Ah Batteries

In Standby mode, the charger is not charging or providing any power to the battery. Energy Save is activated during this mode, drawing microscopic

power from the electrical outlet. Canbus is enabled in Standby mode. When in Standby, the orange Standby LED will illuminate.

For charging 12-volt Wet Cell, Gel Cell, Enhanced Flooded, Maintenance-Free and Calcium batteries. When selected, the 12V white LED will illuminate.

For charging 6-volt Wet Cell, Gel Cell, Enhanced Flooded, Maintenance-Free and Calcium batteries. When selected, the 6V white LED will illuminate.

7.25V | 5A | Up To 120Ah Batteries

14.8V | 5A | Up To 120Ah Batteries

For charging 12-volt AGM batteries. When selected, the 12V AGM white LED will illuminate.

14.6V | 5A | Up To 120Ah Batteries

For charging 12-volt lithium-ion batteries, including lithium iron phosphate. When selected, the 12V Lithium blue LED will illuminate. For use on

batteries with Battery Management Systems (BMS) only.

Force Mode

For charging batteries with a voltage lower than 1V. Press and Hold for ﬁve (5) seconds to enter Force Mode. The selected charge mode will then

operate under Force Mode for ﬁve (5) minutes before returning to standard charging in the selected mode.

5A | Up To 120Ah Batteries

Press & Hold

(5 Seconds)

An advanced battery recovery mode for repairing and restoring, old, idle, damaged, stratiﬁed or sulfated batteries. When selected, a red LED will

illuminate and ﬂash.

Current conditioning up to 16.5V.

How To Use

Charging Modes.

The GENIUS5 has seven (7) modes: Standby, 12V, 12V AGM, 12V LITHIUM, 6V, REPAIR and FORCE. Some charge modes must be pressed and held for three (3) to ﬁve (5)

seconds to enter the mode. These “Press and Hold” modes are advanced charging modes that require your full attention before selecting. It is important to understand the

dierences and purpose of each charge mode. Do not operate the charger until you conﬁrm the appropriate charge mode for your battery. Below is a brief description:

(Peak Voltage Measured At 25°C, Amperage Rating Is Bulk Amperage When Above 0°C)

[From Standby Press and Hold 3 Seconds With Clamps Connected to the Battery]