To Next Page

To Previous Page

4.) Position yourself and free end of cable as far away from battery as possible - then connect NEGATIVE (BLACK) battery clamp or eyelet terminal connector to free

end of cable.

5.) Connect the battery charger into a suitable electrical outlet. Do not face the battery when making this connection.

6.) When disconnecting charger, always do so in reverse sequence of connecting procedure and break ﬁrst connection while as far away from battery as practical.

7.) A marine (boat) battery must be removed and charged on shore. To charge it on board requires equipment specially designed for marine use.

Begin Charging.

1.) Verify the voltage and chemistry of the battery.

2.) Conﬁrm that you have connected the battery clamps or eyelet terminal connectors properly and the AC power plug is plugged into an electrical outlet.

3.) [First time use] The charger can now be left connected to the battery at all times to provide maintenance charging.

4.) Press the mode button to toggle to the appropriate charge mode (press and hold for three seconds to enter an advanced charge mode) for the voltage and

chemistry of your battery.

5.) The mode LED will illuminate the selected charge mode and the Charge LEDs will illuminate (depending on the health of the battery) indicating the charging

process has started.

6.) The charger can now be left connected to the battery at all times to provide maintenance charging.

Auto-Memory: The charger has built in auto-memory and will return to the last charge mode when connected. To change modes after the ﬁrst use, press the mode

button.