EasyManuals Logo

Nokia 3000 User Manual

Nokia 3000
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #85 background imageLoading...
Page #85 background image
General instructions for cellular RF troubleshooting
Most RF semiconductors are static sensitive
ESD protection must be applied during repair (ground straps and ESD soldering irons).
Measuring equipment
All measurements should be done using:
An oscilloscope for low frequency and DC measurements. Recommended probe: 10:1, 10 Mohm//8 pF.
Willtek 440x/3100, Rohde & Schwarz CMU-200 or CMW-500 radio communication tester.
Note: A mobile phone WCDMA transmitter should never be tested with full TX power (permitted
only if measurements and tests are performed in an RF-shielded environment). Even low power
WCDMA transmitters may disturb nearby WCDMA networks and cause problems to 3G cellular
communication in a wide area.
Note: All measurements with an RF coupler should be performed in an RF-shielded environment
because nearby base stations can disturb sensitive receiver measurements. If there is no possibility
to use an RF-shielded environment, testing at frequencies of nearby base stations should be avoided.
Note: All communication test set screen dumps are from CMU-200. Other testers are different.
RF auto tune
Cellular RF parameters should always be re-tuned by means of Testing and Tuning Tool if one or more of the
RF components have been changed or memory (D3000) is corrupted.
RF shield cans
Once a peel-off type RF shield can is opened, a repair lid should always be installed. RF shielding does not
work at all if RF shield cans are left open.
Level of repair
The scope of this guideline is to verify functionality of the cellular RF block as well as possible without
removing RF shields.
Cellular RF key components
Linko RF has the following key components:
Älli N7512 (Transceiver RF ASIC)
Aura N7509 (RF power management ASIC)
UKKO N7510 (Power amplifier, PA)
QuBBE Z7513 (Front end module)
Linko RF has separate RF shielding cans for:
N7512 + surroundings (Shield C)
Z7513 + PA N7510 (Shield B)
Aura N7509 + surroundings (Shield A)
RM-781
Cellular RF troubleshooting
Issue 1 COMPANY CONFIDENTIAL Page 4 – 5
Copyright © 2011 Nokia. All rights reserved.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nokia 3000 and is the answer not in the manual?

Nokia 3000 Specifications

General IconGeneral
NetworkGSM
SIMMini-SIM
PhonebookYes
Call recordsYes
WLANNo
2G bandsGSM 900 / 1800
Alert typesVibration
MessagingSMS
GamesYes
BatteryRemovable battery
ColorsBlack, White, Pink, Blue, Green
StatusCancelled

Related product manuals