•
GSM Modulation & Switching spectrum
•
GSM Burst Template
•
GSM Phase Error
•
WCDMA RSSI
•
WCDMA SNR
•
WCDMA TX Max Output Power
•
WCDMA ACPR
•
WCDMA EVM
Troubleshooting with Testing And Tuning Tool
Context
If limit fails occur while RF tests are performed with Testing And Tuning Tool, the user has to be very careful
to understand the measurement results. Fails may occur because of many reasons:
1 RF attenuation between the phone and the communication tester is something else as expected by the
Testing And Tuning Tool
. Please check that cable, splitter and shield box selections are correct in the
Testing And Tuning Tool
main window.
2 Test limits (specified in the product specific data package) are quite tight. Small limit violations do not
always mean that the tested product is broken, but the RF performance may not be as good as it should
be.
3 RX measurements (RSSI, SNR) may fail because of strong signals from base stations nearby. It is
recommended to always perform RF measurements in an RF-shielded environment (in an RF-shield box
or room).
4 The phone is really broken and needs more specific troubleshooting. Typical for these cases is that
RF
Testing
gives measurement results which are far from the test limits.
Note: Start the more specific troubleshooting always from the chapter Cellular RF main
troubleshooting (page 4– 0 ) . The troubleshooting flow below may be misleading if followed
without upper level instructions.
RM-839; RM-840; RM-841
Cellular RF troubleshooting
Issue 1 NOKIA INTERNAL USE ONLY Page 4 – 13
Copyright © 2013 Nokia. All rights reserved.
To Previous Page
Loading...
Need help?
General
Weight and Dimensions
