Getting started
5
English
1. Place the stencil in the correct
position and draw the outline.
2. Carefully cut out your new cut-
out cover.
Tip: The Nokia PC Suite
provides within the image
editor a tool to create cut-out
covers.
■ Changing the cut-out
cover
1. Remove the back cover from the
phone. See Changing the covers
on page 3.
2. Remove the cut-out cover from
the back cover.
3. Place the new cut-out cover into
the back cover by sliding the cut-
out cover under the two guides at
the bottom (1) and then under
the guide at the top (2).
4. Replace the back cover.
■ Putting on a wrist strap
Remove the back cover and thread
the strap as shown in the picture and
tighten it. Replace the back cover.
9232486_3220_2_en.fm Page 5 Thursday, January 20, 2005 1:31 PM
To Next Page
Loading...
