Get started
14
■ Charge the battery
Check the model number of any charger before use with this device. This device
is intended for use when supplied with power from an AC-3 or AC-4 charger.
Warning: Use only batteries, chargers, and enhancements approved
by Nokia for use with this particular model. The use of any other types
may invalidate any approval or warranty, and may be dangerous.
For availability of approved enhancements, please check with your dealer.
When you disconnect the power cord of any enhancement, grasp and pull the
plug, not the cord.
Connect the charger to a wall socket and the lead
from the charger to the connector on the bottom
of your phone.
If the battery is completely discharged, it may take
a few minutes before the charging indicator appears
on the display or before any calls can be made.
The charging time depends on the charger used. Charging a BL-5B battery with the
AC-3 charger takes approximately 3 hours while the phone is in the standby mode.
■ Open the slide phone
To open the slide of the phone, push the upper part of the phone up.
■ Switch the phone on and off
Warning: Do not switch the phone on when wireless phone use
is prohibited or when it may cause interference or danger.
Press and hold the power key. See "Keys and parts," p. 16. If the phone asks
for a PIN or a UPIN code, enter the code (displayed as ****), and select OK.
Set the time and date
Enter the local time, select the time zone of your location in terms of the time
difference with respect to Greenwich Mean Time (GMT), and enter the date.
See "Time and date," p. 42.
Plug and play service
When you switch on your phone for the first time, and the phone is in the standby
mode, you may be asked to get the configuration settings from your service
provider (network service). Confirm or decline the query. See "Connect to service
provider support," p. 50, and "Configuration settings service," p. 10.
To Next Page
Loading...
Need help?
General
