Call functions
Copyright © 2007 Nokia. All rights reserved. 22
Note: Using voice tags may be
difficult in a noisy environment
or during an emergency, so you
should not rely solely upon
voice dialing in all
circumstances.
1. In the standby mode, press and hold
the right selection key. A short tone is
played, and Speak now is displayed.
If you are using a compatible headset
with the headset key, press and hold
the headset key to start the voice
dialing.
2. Say the voice command clearly. If the
voice recognition is successful, a list
with matches is shown. The phone
plays the voice command of the
match on the top of the list. After
about 1.5 seconds, the phone dials
the number; or if the result is not the
correct one, scroll to another entry,
and select to dial the entry.
Using voice commands to carry out a
selected phone function is similar to
voice dialing. See Voice commands in
“My shortcuts,” p. 52.
■ Answer or reject a
voice call
To answer a call, press the call key.
To answer the call by opening the slide,
see also Slide call handling in “Call,”
p. 58.
To mute the ringing tone before you
answer the call, select Silence.
To end the call or reject a call, press the
end key.
Call waiting
During a call, to answer the waiting call,
press the call key. The first call is put on
hold. To end the active call, press the end
key.
To activate the Call waiting function, see
“Call,” p. 58.
■ Options during a voice
call
Many of the options that you use during
a call are network services.
For availability, contact your network
operator or service provider.
Call options are Mute or Unmute,
Contacts, Menu, Lock keypad, Record,
Loudspeaker, or Handset.
Network services options are Answer,
Reject, Hold or Unhold, New call, Add to
conference, End call, End all calls, and the
following:
Send DTMF — to send tone strings
Swap — to switch between the active call
and the call on hold
Transfer — to connect a call on hold to an
active call and disconnect yourself
To Next Page
Loading...
