Nokia 6290 - Page 172

Copyright © 2007 Nokia. All rights reserved.
Settings
74
Automatic redial — to set the phone to make a maximum
of 10 attempts to connect the call after an unsuccessful
call attempt. Press the end key to stop automatic
redialing.
Summary after call — to set the phone to briefly display
the approximate duration of the last call
Show call duration — to set the phone to display the call
duration during a call
Speed dialling > On — to set the phone to dial the
numbers assigned to the speed dialing keys, 2 to 9, by
pressing and holding the corresponding number key
Anykey answer > On — to answer an incoming call by
briefly pressing any key, except the left and right selection
keys, volume keys, and the end key
Line in use (network service) — shown only if the SIM card
supports two subscriber numbers, that is, two phone lines.
Select which phone line (Line 1 or Line 2) you want to use
for making calls and sending short messages.
Calls on both lines can be answered irrespective of the
selected line. You cannot make calls if you select Line 2
and have not subscribed to this network service. To
prevent line selection, select Line change > Disable if
supported by your SIM card. To change this setting, you
need the PIN2 code.
Call divert
Call divert is a network service.
1 Select which calls you want to divert: Voice calls, Data
and video calls, or Fax calls.
2 Select the desired option. For example, to divert voice
calls when your number is busy or when you reject an
incoming call, select If busy.
3 To set the divert option on or off, select Activate or
Cancel. To check whether the option is activated, select
Check status. Several divert options can be active at
the same time.
Call barring and call diverting cannot be active at the same
time.
Call barring
Call barring (network service) allows you to restrict the
calls that you make and receive with your phone. To
change the settings, you need the barring password from
your service provider.
Scroll to the desired barring option, and to request the
network to set call restriction on, select Options >
Activate. To set the selected call restriction off, select
Cancel. To check whether the calls are barred, select Check
status. To change the barring password, select Edit
barring password. To cancel all active call barrings, select
Cancel all barrings.