WCDMA RX chain activation for manual measurement/WCDMA RSSI measurement
Prerequisites
Make the following settings in Phoenix service software and in the signal generator.
Setting Band IV
Phoenix channel 1637
Signal generator to antenna connector 2132.4 MHz
Steps
1. Via Phoenix Testing menu, choose WCDMA/RX Control.
2. In the RX control window, make the following settings:
Figure 16 RX Control window with example settings
3. Click Start to activate the settings.
If the settings are changed later on (for example, change of channel) you have to click Stop and Start
again.
Note: Clicking Stop also disables TX control if it was active.
4. From the Phoenix testing menu, select WCDMA→RX Power measurement
5. In the RX Power measurement window, select:
• Mode: RSSI
RM-240
RF troubleshooting
Issue 1 COMPANY CONFIDENTIAL Page 4 –13
Copyright © 2007 Nokia. All rights reserved.
To Next Page
Loading...