LED camera flash troubleshooting
Troubleshooting flow
Audio troubleshooting
Audio troubleshooting test instructions
Single-ended external earpiece and internal earpiece outputs can be measured either with a single-ended
or a differential probe.
When measuring with a single-ended probe each output is measured against the ground.
Internal handsfree output is measured using a current probe, if a special low-pass filter designed for
measuring a digital amplifier is not available. Note also that when using a current probe, the input signal
frequency must be set to 2kHz.
The input signal for each loop test can be either single-ended or differential.
Required equipment
The following equipment is needed for the tests:
RM-240
BB Troubleshooting and Manual Tuning Guide
Issue 1 COMPANY CONFIDENTIAL Page 3 –35
Copyright © 2007 Nokia. All rights reserved.
To Next Page
Loading...