PK-1 Software protection
key
PK-1 is a hardware protection key with a USB interface. It has the same
functionality as the PKD-1 series dongle.
PK-1 is meant for use with a PC that does not have a series interface.
To use this USB dongle for security service functions please register
the dongle in the same way as the PKD-1 series dongle.
PKD-1 SW security device
SW security device is a piece of hardware enabling the use of the
service software when connected to the parallel (LPT) port of the PC.
Without the device, it is not possible to use the service software.
Printer or any such device can be connected to the PC through the
device if needed.
RJ-157 Rework jig
RJ-157 is a jig used for soldering and as a rework jig for the engine
module. It is used together with the ST-55 stencil.
RJ-184 Rework jig
RJ-184 is used as a rework jig for the engine module.
This jig is used in conjunction with the ST-61 stencil for spreading the
soldering paste to the B2201 component.
RJ-196 Rework jig
RJ-196 is a rework jig used when servicing the BTHFM (D6000) module.
It is used together with rework stencil ST-37.
RM-240
Service Devices and Service Concepts
Issue 1 COMPANY CONFIDENTIAL Page 2 –9
Copyright © 2007 Nokia. All rights reserved.
To Next Page
Loading...