Copyright © 2004 Nokia. All rights reserved.
Your phone
19
Options during a call
Many options that you can use during a call are network services. Press Options during a
call for some of the following options:
Mute or Unmute, End active call, End all calls, Hold or Unhold, New call, Conference, Private, Drop
participant, Answer, and Reject.
Swap is used to switch between the active call and the call on hold
Transfer is used to connect an incoming call or a call on hold with an active call and to
disconnect yourself from both calls.
Send DTMF is used to send DTMF tone strings, for example, passwords or bank account
numbers.
1 Key in the digits with - . Each keystroke generates a DTMF tone, which
is transmitted while the call is active. Press repeatedly to produce: *, p (inserts
a pause of approx. two seconds before, or between DTMF characters.), and w (if you use
this character, the remaining sequence is not sent until you press Send again during
the call). Press to produce #.
Glossary: DTMF
tones are the tones you
hear when you press the
number keys on the phone
keypad. DTMF tones allow
you to communicate with
voice mailboxes and
computerised telephony
systems, for example.
2 To send the tone, press OK.
Tip! You can also store a sequence of DTMF tones for a contact card. When you
make a call to the contact, you can retrieve the sequence. Add DTMF tones to the
phone number or DTMF fields in a contact card.
Settings for call diverting
When this network service is activated, you can direct your incoming calls to another
number, for example, to your voice mailbox number. For details, contact your service
provider.
Go to Menu → Tools
→ Call divert.
• Select one of the divert options, for example, select If busy to divert voice calls when
your number is busy or when you reject incoming calls.
Fig. 3 Options during a
call.
To Next Page
Loading...
