Copyright © 2004 Nokia. All rights reserved.
Settings
35
Note: Charges may apply for certain types of received calls, such as roaming and
high speed data calls. Contact your GSM network operator for more information.
Note: The phone expects the callback call to use the same data call settings that
were used in the callback-requesting call. The network must support that type
of call in both directions, to and from the phone.
• Callback type - The options are Use server no. / Use other no.. Ask your service provider for
the correct setting to use; it will depend on the service provider’s configuration.
Glossary: PPP
(Point-to-Point Protocol) -
a common networking
software protocol that
enables any computer
with a modem and a
phone line to connect
directly to the Internet.
• Callback number - Key in your phone’s data phone number which the dial back server
uses. Usually, this number is the data call phone number of your phone.
• Use PPP compression - When set to Yes, this option speeds up the data transfer, if
supported by the remote PPP server. If you have problems with establishing a
connection, try setting this to No. Contact your service provider for guidance.
• Use login script - The options are Yes / No.
• Login script - Insert the login script.
• Modem initialisation (Modem initialisation string)- Controls your phone using modem AT
commands. If required, enter characters specified by your GSM network service provider
or Internet service provider.
GPRS
Go to Settings →
Connection → GPRS.
The GPRS settings affect all access points using a packet data connection.
GPRS connection - If you select When available and you are in a network that supports
packet data, the phone registers to the GPRS network and sending short messages will be
done via GPRS. Also, starting an active packet data connection, for example, to send and
receive e-mail, is quicker. If you select When needed, the phone will use a packet data
connection only if you start an application or action that needs it. The GPRS connection is
closed after it is not used by any application.
Note: If there is no GPRS coverage and you have chosen When available, the phone
will periodically try to establish a packet data connection.