Reference information
42
PUK2 code (8 digit)
The PUK2 code, supplied with some
SIM cards, is required to change a
blocked PIN2 code.
If you key in an incorrect PUK2 code
ten times in succession, you cannot
use the functions requiring the PIN2
code. Contact your service provider
for a new card.
You cannot change the PUK2 code. If
you lose the code, contact your
service provider.
Barring password
The barring password is needed
when using the ‘Call barring’
function. You obtain the password
from your service provider.
■ Ciphering indicator
Depending on the network, the
ciphering indicator may be
displayed during a call to notify that
call encryption is off.
For more information, contact your
network operator.
■ Battery information
Li-Ion battery BLB-2 is the
manufacturer-approved
rechargeable battery is available for
your phone.
Charging and discharging
the battery
• Your phone is powered by a
rechargeable battery.
• Never remove or replace the
battery when the phone is
connected to the charger.
• Note that a new battery’s full
performance is achieved only
after two or three complete
charge and discharge cycles!
• The battery can be charged and
discharged hundreds of times but
it will eventually wear out. When
the operating time (talk-time and
stand-by time) is noticeably
shorter than normal, it is time to
buy a new battery.
• Use only batteries approved by
the phone manufacturer and
recharge your battery only with
the chargers approved by the
manufacturer.
• When a charger is not in use,
disconnect it from the power
source. Do not leave the battery
connected to a charger for longer
than a week, since overcharging
may shorten its life. If left unused
a fully charged battery will
discharge itself over time.
• Temperature extremes will affect
the ability of your battery to
charge: allow it to cool down or
warm up first.
To Next Page
Loading...
