Bluetooth BER Test
SB-6 Bluetooth test box (BT-box) is required to perform a BER (Bit Error Rate) test. If a BT-box is not available
Bluetooth functionality can be checked by transferring a file to another Bluetooth phone.
Steps:
1 Place the phone in the flash adapter or connect data cable to phone.
2 Start Phoenix service software.
3 Choose
File
→
Scan Product
.
4 Choose
Testing
→
Bluetooth LOCALS
5 Locate the BT-box serial number (12 digits) found in the type label on the back of the SB-6 Bluetooth test
box.
6 In the
Bluetooth LOCALS
window, write the 12-digit serial number on the
Counterpart BT Device
Address
line.
7 Place the BT-box near (within 10 cm) of the phone and click Run BER Test.
RM-704
RF Troubleshooting
Issue 1 COMPANY CONFIDENTIAL Page 4 – 55
Copyright © 2011 Nokia. All rights reserved.
To Next Page
Loading...
