Get started
6
1. Get started
■ Display and standby mode
Attach the display to the mounting
plate
To use the car kit, slide the display onto the
mounting plate.
To detach the display, switch off the car kit, and
slide the display upwards from the mounting
plate.
Information displayed in standby mode
When you switch on the car kit, it enters standby mode.
In standby mode, the Bluetooth name of the connected device is
displayed. If the car kit is connected to two devices, the primary device is
displayed above the secondary one. Also the signal strength, name of
the service provider, and battery charge of the connected device are
displayed. If the car kit is connected to two devices, this information is
displayed for the primary device.
Display indicators
You have an active call.
You have a call on hold.
There is an incoming call.
There is an outgoing call.
You have missed calls in the device that is displayed above the
indicator.
The call is switched to the connected mobile device.
To Next Page
Loading...
