Data Network Terminal Single-port and Multiport Operating Instructions
26 (128) © Nokia Corporation DN01145897
Nokia Proprietary and Confidential Issue2-0en
Caution
To insert DTE interface units:
1. Make sure that the power is switched off.
The multiport version of DNT2Mi has three slots and the DTE interface units that
go to the upper slots (2 and 3) need to be inserted upside down.
2. Insert a DTE interface unit carefully into the slot.
3. Tighten the two screws.
Figure 12. Inserting DTE interface units into DNT2Mi (single-port)
Screws
To Next Page
Loading...
Need help?
General
