Installing DNT2Mi
DN01145897 © Nokia Corporation 27 (128)
Issue 2-0 en Nokia Proprietary and Confidential
Note
Caution
Note
5.6 Free-standing installation
A free-standing installation of DNT2Mi is allowed only if permitted by the local
electric safety regulations!
To install DNT2Mi free-standing:
1. Place DNT2Mi on a dry and clean horizontal level.
Make sure that the unit may not be dropped incidentally!
2. Guide the strain relief as advised in Figure 24.
3. Take care of the grounding as advised in Section 5.2.
5.7 Installing DNT2Mi on a wall or into a rack
This section gives instructions for the mechanical installation of DNT2Mi into a
19-inch rack or on a wall.
The mounting accessories used are:
• DS 62000.1 Modem shelf for low housing (single-port, 7 units)
• DF 62001.1 Wall-mounting bracket
• DF 62010.1 DC-power rail.
5.7.1 Installing DNT2Mi on a wall
When selecting an installation location, make sure that all cables can be easily
connected. See Figure 11 for adequate clearances.
To Next Page
Loading...
Need help?
General
