Nokia DNT2Mi sp/mp - Page 66

Data Network Terminal Single-port and Multiport Operating Instructions
66 (128) © Nokia Corporation DN01145897
Nokia Proprietary and Confidential Issue2-0en
Figure 42. Configuring ports / G.704 interfaces
BER alarm sever.
No alarm
BER alarm sever.
A-level
OK
EX
OK
EX
OK
EX
OK
EX
EX
OK
DTE if alarms
Disabled *
OK
EX
OK
EX
OK
...
...
OK
TS0 bit Sa8
Fixed to 1 *
...
Remote loop
Allowed *
OK
EX
BER alarm limit
1E-3 *
OK
EX
BER alarm sever.
B-level *
OK
EX
TS0 bit Sa8
Fixed to 1
TS0 bit Sa8
Fixed to 0
DTE if alarms
Disabled *
DTE if alarms
Enabled
Remote loop
Allowed *
Remote loop
Not allowed
BER alarm limit
1E-3 *
BER alarm limit
1E-6
BER alarm sever.
B-level *
BER alarm sever.
AS-level
OK
EX
OK
EX
OK
EX
Not with D2048 adapter
TS map
Equal to line *
Idle Channels
Code FF *
Sa4...Sa8 bits
11111 *
Save? OK/Exit
Configure
Port 1
Framing format
Basic frame *
Configure
Port 2
Configure
Port 3
Accept
Dismiss
TS0 bit Sa5
Fixed to 1 *
Only with D2048
adapter
Framing format
Basic frame *
Framing format
CRC multiframe
Framing format
CRC monitoring
TS map
Equal to line *
TS map
First TS=1
TS map
First TS=31
Idle Channels
Code FF *
Idle Channels
Code FF
Idle Channels
Code 00
TS0 bit Sa4
Fixed to 1 *
TS0 bit Sa4
Fixed to 1
TS0 bit Sa4
Fixed to 0
TS0 bit Sa5
Fixed to 1
TS0 bit Sa5
Fixed to 0
Framing format
BF monitoring
Framing format
No frame
EX
...
TS map
Special TS= *
TS map
Special TS= *
TS map
Special TS=01
TS map
Special TS=31
OK
----