Tools
96
You can also use a wireless LAN data connection. 
See “Wireless LAN”, p. 12. Only one connection in one 
wireless LAN can be active at a time.
To establish a data connection, an access point is required. 
You can define different kinds of access points, such as:
• MMS access point to send and receive multimedia 
messages.
• Access point for the Web application to view WML or 
XHTML pages.
• Internet access point (IAP) to send and receive e-mail 
and connect to the Internet.
Check the type of access point you need with your service 
provider for the service you want to access. For availability 
and subscription to packet data connection services, 
contact your network operator or service provider.
Access points
You may receive access point settings in a message from 
a service provider. See “Data and settings”, p. 48. Some or 
all access points may be preset for your device by your 
service provider or network operator, and you may not be 
able to change, create, edit, or remove them.   indicates 
a protected access point.
 indicates a packet data access point, and   a 
wireless LAN access point.
Tip!To create an Internet access point in a wireless 
LAN, press  , and select Connect. > Conn mgr > 
Availab. WLAN > Options > Define access point.
To create a new access point, select Options > New access 
point. To edit the settings of an access point, 
select Options > Edit. Follow the instructions from your 
service provider.
Connection name—Enter a descriptive name for the 
connection.
Data bearer—Select the data connection type.
Depending on the data connection you select, only certain 
setting fields are available. Fill in all fields marked with 
Must be defined or with a red asterisk. Other fields can be 
left empty, unless you have been instructed otherwise by 
your service provider.
To be able to use a data connection, the network service 
provider must support this feature, and if necessary, 
activate it for your SIM card.
Packet data
Follow the instructions from your service provider.
Access point name—You obtain the access point name 
from your network operator or service provider.
User name—The user name may be needed to make a data 
connection, and is usually provided by the service provider.
9244700_N80-1_en_zh.book  Page 96  Thursday, March 23, 2006  2:34 PM