Nokia NSM–3 User Manual

NSM–3/3D
Service Software Instructions
PAMS Technical Documentation
Page 41
Issue 4 02/2002
 Nokia Mobile Phones Ltd.
When TX is selected, the next functions are made:
Data transmission is activated
If operation mode is continuous,
– Operation mode is set to burst
RF Information window is updated
Continuous mode radio button is disabled.
Note! Function is activated immediately, Apply is not needed.
Operation Mode group:
Continuous radio button (ALT+C):
When
continuous selection is used,
synthesizer is set to constant frequency
synthesizer channel number is as given with Continuous Mode
Channel selection
transmitter power is not connected
if Active Unit is RX, AGC is controlled
Note! Function is activated immediately, Apply is not needed.
Burst radio button (ALT+B):
When
burst selection is used,
synthesizer is controlled by using receiving/transmission/
measuring synthesizer control sequence
synthesizer channel numbers are as given with Channel/
Monitoring Channel selections
if Active Unit is TX, data (selected with TX Data Type) is sent
and the TX power is connected
Note! Function is activated immediately, Apply is not needed.
TX D
ata Type drop list (ALT+D):
This list changes the transmission data type. List consists fol-
lowing options: 0, 1, Random and User. After Random data
selection 0 is used. If Operating Mode is
continuous , TX Data
Type Random causes different data sending than in burst
mode. User data is defined in TESLA.INI file by the user
(open).
TX Power Level edit box (ALT+T):
With this value is possible to change the transmission power.
The user can give the needed power value or select the test
value, which is tuned with TX power tuning function. The test
value is found at the end of the list.
TX Power have value
OFF and is disabled ( greyed ) when ac-
tive unit is RX. When the TX power is tuned with test value
(smallest value) the TX Power has value
TEST .

Nokia NSM–3 Specifications

General

Brand	Nokia
Model	NSM–3
Category	Cell Phone
Language	English