If the settings are changed later on (for example, change of channel) you have to click Stop and Start
again.
Note: Clicking Stop also disables TX control if it was active.
WCDMA RSSI measurement
Prerequisites
WCDMA RX must be activated before RSSI can be measured. For instructions, please refer to WCDMA RX chain
activation for manual measurement (page 4–13).
Connect signal generator to RF connector and use appropriate frequency for each channel.
Steps
1. In Phoenix select Testing→WCDMA→RX Power measurement . The Rx Power Measurement window
opens.
Figure 18 Phoenix Rx Power Measurement window
2. In the RX Power measurement window, select:
•
Mode: RSSI
•
Continuous mode
3. Click Start to perform the measurement.
Note: WCDMA RSSI measurement is accurate only with WCDMA modulated signal.
RM-598; RM-604
RF Troubleshooting
Page 4 –14 COMPANY CONFIDENTIAL Issue 1
Copyright © 2009 Nokia. All rights reserved.
To Next Page
Loading...
