IMPORTANT DETAILS ABOUT MENU USAGE:
* If no button is pressed for a few seconds after accessing the menu, the device will go back
to the main screen. If you do not want to wait, you can press and release the pinpoint
button once to go to the main screen as well.
* Do not turn off the device while the menu screen is displayed. If you turn off the device
while in the menu and made changes in the personal settings (volume, brightness,
cm/inch and language) the changes will not be saved.
* You do not need to confirm or exit the menu to save the changes. New values will take
effect immediately.
* When you select the ''brightness'' option in the menu, the backlight will turn on and
number ''88'' will appear on the numeric display. This way, the user can see the correct
brightness level on screen and adjust it accordingly.
* If you change the language of the device to a foreign language by mistake, the text on
screen may make no sense for you. Therefore, language is placed as the last option in the
menu. In such a case, go to the last option and select your own language.
* When you press and hold the menu buttons, the menu options and values will change
more rapidly.
* Disabled menu options ( that cannot be changed by the user) will appear grayed out. The
disabled option may be active in another mode. (For example; ID Masking appears
disabled in the General Search mode but active in other modes).
SEARCH MODES
GENERAL SEARCH MODE (GEN):
Sometimes referred to as the ''All Metal'' mode, this is the deepest mode of the device.
Different than the other modes, this mode has a constant threshold sound in the
background that enables the user to use his/her own judgment.
In the General Search mode, the device will detect all targets (metal, high mineralized
rocks etc.) without discrimination. The ID of the detected target will be displayed on the
screen (except for negative rocks) and the device will emit the same tone for all targets. The
audio warning tone will increase in pitch as the coil approaches the target.
In this mode, the sensitivity and threshold settings are preset by the factory for best
performance on most soil types. If you want, you can change these settings based on
ground conditions in your search field.
ID Masking, Iron Volume and Tone Break settings are not available in this mode so they
disabled in the menu.
We recommend using the General Search mode when discrimination is not necessary and
not using it in heavy trash areas or areas containing many hot rocks.
DEVICE INTRODUCTION
Page 12
To Next Page
Loading...
Need help?
General