At the bottom of the LCD panel, on the main screen, messages will appear if any. If there is
no message, the present search mode name will be displayed. Messages that may appear
are as follows:
OVERLOAD:
It appears simultaneously with the overload warning alarm sounding like a siren. This
happens when the search coil encounters a shallow or a very large object. The device will
revert back to normal operation if you lift the coil up. If the alarm and the message
continues along a long line, you may be over a long metal such as a pipe.
PUMP THE COIL:
It appears when the ground balance button is held pressed for automatic ground
balancing. It does not indicate any issues or errors. It just tells you what to do.
COIL NOT CONNECTED:
It indicates an interruption in the search coil transmitter signal. The search coil connector
may be unattached, loose or disconnected. If you own another detector with the same coil
connector, please be sure that you have not attached the wrong coil by mistake. If none of
the above exists, the search coil or its cable may have a defect. If the issue continues when
you change the search coil, there may be an issue in the coil control circuit.
LOW BATTERY:
This message appears when the battery level drops below a certain point. The device may
continue to work a few more hours. Meanwhile, please change the batteries.
MESSAGES
The technical settings of the device (Mode, Ground Balance, Sensitivity, Threshold, ID
Masking, iMASK, Frequency) come with their factory default values at each startup.
Personal settings (Volume, cm/inch, Brightness, and Language) come with the last
adjusted value when the device is turned off and on again.
You can customize and save your startup settings by following the steps below:
1. Go to the menu screen and be sure that all the options are at the desired setting.
2. Wait and exit the menu.
3. On the main screen, press and hold one of the up or down buttons for at least 4 seconds.
The menu screen will appear; do not let go of the button!
4. Keeping the button pressed, press the '-' (minus) button. ''Please wait'' message will
appear on screen. You can let go of the buttons.
5. Wait while the message is on screen. In about 4-6 seconds, the process will finish and the
menu screen will come up. It is normal for the device to emit different sounds during this
process.
6. Turn off and on the device again. Go to the menu to check whether your desired startup
settings are saved or not.
FACTORY and STARTUP SETTINGS
Page 27
To Next Page
Loading...
Need help?
General