23
X-804
INSTRUCTIONS FOR USE
- To preserve the visor’s condition over time, leave the helmet to dry in a ventilated
and dry place with the visor open after use. Keep it away from heat sources and
store it in a place away from direct light.
- Do not use solvents or chemical products.
TEAR-OFF PROTECTIVE FILM
(
XFR
-
03
)
(Available as standard or accessory/spare part)
This accessory allows improved helmet performance under certain conditions of use.
Through the removal of these tear-off visor protectors, to be used exclusively for track
competitions, the visibility performance of the visor is maintained by preventing the
accumulation of ies and/or dirt.
The helmet’s at visor is equipped with two external pins through which the Tear-Off
protective lms can be attached. The visor is supplied with two pins that can be ad-
justed by an eccentric screw that allows the Tear-Off protective lms to be correctly
tensioned.
1 ASSEMBLY
1.1 Adjust the outer pins by turning them so that they show the arrow (Fig. 10) towards
the inside of the visor.
1.2 Take the Tear-Off protective lms and remove the protective lms placed on both
surfaces (Fig. 11).
1.3 Apply the Tear-Off protective lm to the visor by inserting the right slot into the
appropriate right pin (Fig. 12).
1.4 Perform the same operation on the left side of the visor.
The left side of the Tear-Off lms has an elongated shape towards the outside
compared to the right side (Fig. 13).
1.5 Check that the Tear-Off lm perfectly adheres to the visor and tension the lm to
the maximum by turning the pins with eccentric screw.
When the arrow on the pins (Fig. 14) is positioned towards the inside of the
visor, the tension is minimal; by gradually rotating the pin, the tension increas-
es, reaching its maximum level when both pins have the arrows in the outer
position.
To tear off the Tear-Off lm from the visor, pull the elongated, protruding part of the
Tear-Off lm with a rm forward movement so that the slot disengages from the pin.
We recommend placing the protruding side of the Tear-Off lm on the left side of
the helmet, so as to allow the protective lm to be torn off with the left hand.
WARNING
- The combination of the Tear-Off lm and the helmet visor can slightly reduce trans-
mittance values and increase light scattering values. For this reason, use of the
two visors together is not approved.
- Use the Tear-Off protective lms exclusively for track competitions. Do not use
them for normal road use.
- Do not apply more than one Tear-Off lm at a time as this would create optical
distortion and reduced visibility.
- Damaged or scratched visors and Tear-Off protective lms must not be used and
must be replaced.
To Next Page
Loading...
Need help?
General
