Customer Confidence 8
Step 1d: PPPoE Static IP Client Configuration
Use the same steps for configuring dynamic PPPoE shown in Figure 8 above, but select static for PPP IP Configuration
Mode, and enter your IP address for PPP Static IP Address. A summary page similar to Figure 9 above will be
displayed.
If everything is correct in the summary, type b[ack] to return to the previous menu and proceed to Step 2 to enter the
location information.
Otherwise, select an option from the Ethernet port configuration menu to display or make changes to the WAN port
settings. When finished with the settings, type b[ack] to return to the previous menu and proceed to Step 2 to enter
the location information.
To Next Page
Loading...
