① Slaves: When LED indicator is always on, press & hold the L key until LED
indicator turns green then loosen it. Then click the L key (the green
indicator light flashes) to standby. (all of slaves do the same)
② Master: When LED indicator is always on blue, press & hold the L key,
loosen it when the indicator flashing. (Master send a command to the slave,
then green indicator of slave stop flashing)
Note：After adding a new light as a slave, the brightness is different with
other slaves, how to sync? Operation: Click the L key of Master to turn the
indicator be red, press & hold the L key until the indicator flashes red, then
loosen the L key to send data to the slaves to sync data.
LAN connection
To Next Page
Loading...