Norac UC5 - Page 51

To Next Page

To Previous Page



49



CalibratingBoomGeometry

1. Ensurethesprayerisoverbarelevelsoilorgravel.

2. Ensuretheboomislevelandapproximately3–5feet(100‐150cm)abovetheground.

3. Navigatetotheboomgeometrytest(RunScreen‐>Settings‐>Next‐>Setup‐>BoomGeometry

Test).

4. Theboomswillbemovedintopositionand,thedisplaywillpromptyoutoexitthecabandmanually

pusheitherboomtipdown.Stayatleast3feetfromthesensor.

5. Pusheitherboomtipdown 1–3  feet(30–90cm)foramoment

and thenletgo.Do notpushthe

boomtotheground.

 

Other manuals for Norac UC5