Owner’s Manual 6
Operating the Refrigerator Controls
Control panel:
The refrigerator control panel (see Art01838) is between the freezer compartment and the fresh food compartment. A 12 volt DC power
supply is necessary for the control functions of the refrigerator to operate. The refrigerator receives DC power from the 12 volt system
of the vehicle; either an auxiliary battery, a converter, or the vehicle engine battery.
The selector switch [207] starts and shuts down the refrigerator:
- Push the selector switch to the AUTO position to start the
refrigerator in auto mode.
- Push the selector switch to the GAS position to start the
refrigerator on propane gas.
The temperature switch [142] controls the temperature adjustment
of the freezer and the fresh food compartment. The temperature
adjustment that you select does not change if the mode of
operation of the refrigerator changes.
- Push the temperature switch to the desired temperature
setting.
- The number “5” is the coldest temperature setting.
Refer to the “Display Codes” section of this manual.
AUTO OFF GAS COLD COLDEST
1 2 3 4 5
ON
GAS check if flashing
207
142
62
60
Art01838
Backup operating system:
This refrigerator has a backup operating system. The backup operating system allows the regerator to continue to cool if the
temperature sensor of the refrigerator should fail.
If this failure occurs:
- The refrigerator automatically changes to the backup operating system.
- The ON light ashes a fault code. See the “Fault Codes” section of this manual.
- The backup operating system can overfreeze or thaw the contents of the freezer and the fresh food compartment.
- Make sure the temperatures of the freezer and the fresh food compartment are
satisfactory.
If you open the door(s) too often, the temperatures inside the
freezer and fresh food compartment do not become stable.
Allow the refrigerator to operate for about one hour after
each adjustment change before you examine the contents.
The number “5” is the coldest temperature setting.
- If the temperature is too warm, push the temperature switch to the right to
raise the temperature setting by one number.
- If the temperature is too cold, push the temperature switch to the left to
lower the temperature setting by one number.
- Have the refrigerator serviced by your dealer or an Norcold authorized Service
Center as soon as possible.
Temperature switch monitor:
The refrigerator is equipped with a temperature switch [142] for overheating protection
(See Art01869). A Norcold authorized service technician can determine if this switch
has been triggered.
142
NOTICE