NORDAC Control and Parameter Boxes
2 Subject to technical alterations BU 0040 GB-1611
Intended use of the frequency inverter
The compliance with the operating instructions is necessary for fault-free operation and the
acceptance of possible warranty claims. These operating instructions must be read before
working with the device!
These operating instructions contain important information about service. They must therefore
be kept close to the device.
The control and parameter boxes are only intended for use with NORD frequency inverters or
their accessories (optional modules).
All details regarding technical data and permissible conditions at the installation site must be
complied with.
Commissioning (implementation of the intended use) is not permitted until it has been ensured
that the machine complies with the EMC directive 2004/108/EEC and that the conformity of the
end product meets the machine directive 2006/42/EEC (note EN 60204).
© Getriebebau NORD GmbH & Co. KG, 2011
To Next Page
Loading...
Need help?
General
