nord NORDAC SK 225E - Page 48

NORDAC SK 200E Manual
48 Subject to technical alterations BU 0200 GB
Menu structure with the SimpleBox
P0--
_ _ _ _
P1--
P2 - -
P4--
P5--
P6--
P7--
P001
P00 2
P100
P10 1
P114
P2 00
P201
P220
P400
P4 0 1
P483
Operating value display
(or operational)
following mains ON
P3--
P30 0
P30 1
P327
P0 0 3
To
change a parameter value, the OK key
OK
must be pressed when the relevant parameter number is
displayed.
Changes can then be made using the VALUE keys
or and must be confirmed with
OK
to save them
in the EEPROM and exit from the parameter.
As long as a changed value has not been confirmed by pressing OK, the value has not yet been stored in
the frequency inverter.
During parameter changes, the display does not flash, so that the display is more legible.
If a change is not
to be saved, the "DIRECTION" key can be pressed to exit from the parameter.
Return to operating value
display
Save
changed value
Call up the default settings
for the parameter value
Increase parameter value
Do not save
changed value
Reduce parameter value