Version 3/01 Page 12/25
Reading alarm and warning data:
•
Enter crusher control display (Press F1 in main menu).
•
Select ALARMS (Press F4).
Function keys in alarm mode are as follows:
Key Function Description of function
F1 Select Selects event.
F3 Acknowledge all Acknowledges all events.
F5 Move up Moves cursor upwards on the list.
F6 Move down Moves cursor downwards on the list.
F7 Close Exit to crusher control display.
In the alarm screen you can examine single events by pressing F1. This screen presents
more information, such as setting, pressure, power, etc.
An alarm will be sent if a limit value is exceeded or not reached. An alarm will stop the
device, if necessary. An alarm is often related to the actions of the operator. If a safety
device is triggered, an alarm will follow.
Following additional information is gathered on alarms and warnings:
•
Code and point of sending
•
Measured values; setting, pressure, and power at the time of alarm
•
Operating hours at the time of alarm
•
Number of alarms/warnings of this type within operating hours
•
Time of first alarm/warning of this type
•
Acknowledgement of message; acknowledged events with prefix @
•
Lubrication pressure : OK/not OK
•
Oil filter: OK/not OK
•
Oil temperature: low/OK/high
•
Oil flow: on/off
•
Oil level: on/off
•
Cooler status: on/off
•
Heater status: on/off
To Next Page
Loading...
Need help?
General
