Introduction
Known issues with nPM1300 EK v0.9.0
An issue with the nPM1300 PMIC version used on this EK requires the following actions:
• VSYS (P7) should be connected to LSIN2 and LSOUT2 (P15) on the EK using two jumper wires.
Do not use load switch LSOUT2 for any other purpose. Refer to the nPM1300 errata for more
information.
• The buttons connected to GPIOs on the EK are not working as intended when the nPM Controller
is active. When using the buttons with GPIOs, disconnect the nPM Controller and use the EK with a
Nordic DK or external circuit.
4490_387
8
To Next Page
