6. With the help of a second person, carefully tip
the treadmill onto its right side. Partially fold the
Frame (55) so that the treadmill is more stable;
do not fully fold the Frame yet.
See the inset drawing. Orient the Left Upright
Spacer (90) with the two curved corners posi-
tioned as shown. Set the Left Upright Spacer on
the Base (94).
Hold a Bolt Spacer (88) inside the lower end of
the Left Upright (82). Insert a 3/8" x 5 1/2" Patch
Bolt (7) with a 3/8" Star Washer (11) into the
Left Upright and the Bolt Spacer. Repeat this
step with a second Bolt Spacer (88), 3/8" x
5 1/2" Patch Bolt (7), and 3/8" Star Washer
(11).
Hold the Left Upright (82) against the Left
Upright Spacer (90). Tighten the 3/8" x 5 1/2"
Patch Bolt (7) until the heads of the Patch Bolts
touch the Upright; do not fully tighten the
Patch Bolts yet.
90
82
7
94
88
11
6
9
5. Hold a Bolt Spacer (88) inside the lower end of
the Right Upright (83). Insert a 3/8" x 5 1/2"
Patch Bolt (7) with a 3/8" Star Washer (11) into
the Right Upright and the Bolt Spacer. Repeat
t
his step with a second Bolt Spacer (88), 3/8"
x 5 1/2" Patch Bolt (7), and 3/8" Star Washer
(11).
H
old the Right Upright (83) against the Right
Upright Spacer (91). Be careful not to pinch
the Upright Wire (85) or the ground wire.
Tighten the 3/8" x 5 1/2" Patch Bolts (7) until the
heads of the Patch Bolts touch the Upright; do
not fully tighten the Patch Bolts yet.
83
85
1
1
88
7
5
90
Curved
Corners
91
55
To Next Page
Loading...
