g Attach the clip to the waistband of your
clothing.
Stand on the foot rails
of the TREKKER.
Find the clip attached
to the key and slide
the clip onto the
waistband of your
clothing. Next, insert
the key into the con-
Clip
Key / _,_
sole. Test the clip by carefully taking a few
steps backward until the key is pulled from the
console. If the key is not pulled from the con-
sole, adjust the position of the clip as needed.
Then, remove the key from the console.
B Plug in the power cord.
See HOW TO PLUG IN.THE POWER CORD on
page 8.
[_]Move the on/off switch to the on position.
Locate the on/off switch
on the TREKKER near
the power cord. Move
tile on/off switch to the
on position.
Position
B Insert the key fully into the console.
Stand on the foot rails of the TREKKER. Attach
the clip securely to the waistband of your
clothing.
Next, insert the key into the console. After a mo-
ment, various displays and indicators on the con-
sole will light. Note: When the key is inserted, the
TREKKER may automatically calibrate itself by ris-
ing to the highest grade and then returning to the
lowest grade. If this occurs, the console will show
two dashes (--) and one flashing indicator while
the TREKKER calibrates itself.
To use the manual mode of the console, follow the
steps beginning on page 11. To use a preset pro-
gram, see page 12. To use an iFIT,com CD or video
program, see page 16. To use an iFIT,com program
directly from our internet site, see page 18.
10
To Next Page
Loading...
Need help?
General
