NordicTrack AIRGLIDE 14i - Page 14

14
15
15. Identify the Right Upper Body Arm (61) and have
a second person hold it near the Right Upper
Body Leg (60).
See the inset drawing. Locate the Right Control
Wire (134) in the Right Upper Body Arm (61).
Feed the Right Control Wire into the Upper Body
Leg (60) and out of the indicated hole (D).
Avoid pinching the Right Control Wire (146).
Insert the Right Upper Body Arm (61) into
the Right Upper Body Leg (60). Attach the
Right Upper Body Arm with two M8 x 41mm
Screws (96).
Repeat this step with the Left Upper Body
Arm (47).
60
61
47
96
Avoid pinching
the wires
134
16
16. See the left inset drawing. Connect the Right
Control Wire (134) to the right Extension Wire
(111).
IMPORTANT: The wire connectors should
slide together easily and snap into place with
an audible click. If they do not, turn one con-
nector and try again. You must connect the
wires properly for your elliptical to function
properly.
Then, insert the connectors and the excess wire
into the Upright (4).
See the right inset drawing. Press the Right
Control Wire (134) into the slot in the Wire Clip
(159).
Repeat this step on the left side of the
elliptical.
111
134
134
4
159
134
60
61
D