16
21. Make sure that all parts are properly tightened. Extra parts may be included. Place a mat beneath the
elliptical to protect the floor. Note: Keep the included tools. One or more of the tools may be needed to make
adjustments in the future. To avoid damaging parts, do not use power tools for assembly or adjustment.
20
65
60
101
66
20. Avoid pinching the wires. Orient the Right Arm
Front and Rear Covers (65, 66) around the Right
Upper Body Leg (60) as shown, and attach them
with two M4 x 16mm Screws (101).
Repeat this step on the other side of the
elliptical.
Avoid pinching
the wires
E
19. Identify the Right Leg Inner Cover (83), orient it
as shown, and insert it through the Right Upper
Body Leg (60).
Next, identify the Right Leg Outer Cover (69),
orient it as shown, and press it onto the Right
Leg Inner Cover (83).
Attach the Right Leg Outer and Inner Covers
(69, 83) to each other with an M4 x 16mm
Screw (101).
Repeat this step on the other side of the
elliptical.
60
101
69
19
83
To Next Page
Loading...
