8
4
6
4. With the help of a second person, place some
of the packing materials (not shown) under the
front of the Frame (1). Have the second person
hold the Frame to prevent it from tipping until
you complete this step.
If there are shipping supports attached to the
front of the Frame (1), remove the screws from
the shipping supports, and discard the screws
and the shipping supports.
Next, attach the Front Stabilizer (6) to the Frame
(1) with two M10 x 115mm Screws (104).
Then, remove the packing materials from under
the Frame (1).
1
104
3. Attach the Rear Stabilizer Cover (15) to the Rear
Stabilizer (2) with three M4 x 18mm Machine
Screws (155); start all three Machine Screws,
and then tighten them.
3
1
2
155
15
To Next Page
Loading...
