9
5
7759
45
95
5. Apply a small amount of the included grease to
the axle on the right Crank Arm (20).
Next, identify the Right Roller Arm (59), orient
it as shown, and slide it onto the right Crank
Arm (20).
Attach the Right Roller Arm (59) with an
M8 x 20mm Screw (95) and a Crank Cover (77);
make sure that the Crank Cover is oriented
as shown in the inset drawing.
Repeat this step for the Left Roller Arm (45).
20
95
77
Grease
6
4
110
1
6. Have a second person hold the Upright (4) near
the Frame (1) as shown.
Next, connect the Upright Wire (157) to the Main
Wire (110).
IMPORTANT: The wire connectors should
slide together easily and snap into place
with an audible click. If they do not, turn one
connector and try again. You must connect
the wires properly for your elliptical to func-
tion properly. To see a short video about how
to connect wires, scan the QR code or go to
my.iFIT.com.
157
To Next Page
Loading...
